Skip to main content

1.4.1

Major VersionM

by Adalyn Ordono

Introduction

In this guide, you will learn:

  • What multi-spool mode is used for
  • How to load multiple drives for this mode

Using multi-spool mode allows Palette to automatically switch to a different input when a spool of filament runs out. This allows you to splice partial spools of filament together, or print continuously by having Palette change inputs once one input runs out.

  1. Once you have set up a printer profile, from the Home Screen tap Start Print > Custom Print > Multi-Spool Once you have set up a printer profile, from the Home Screen tap Start Print > Custom Print > Multi-Spool
    • Once you have set up a printer profile, from the Home Screen tap Start Print > Custom Print > Multi-Spool

  2. From the multi-spool mode screen, tap Next and choose which inputs you would like to use to splice the filament together. Choose to either Start with Printer or Start without Printer.
    • From the multi-spool mode screen, tap Next and choose which inputs you would like to use to splice the filament together.

    • Choose to either Start with Printer or Start without Printer.

    • Start with Printer: This can be used to splice to the next drive automatically for long prints. Enough filament will be made to exit the selected outgoing tube. Preheat the printer, load the filament through the extruder under it begins to come out of the nozzle. Confirm on Palette's screen that the printer is loaded, and then start the G-Code.

    • Start without Printer: This method can be used to combine partial spools. Palette will splice from one drive to the next, starting with the first selected drive. Once that first drive runs out, it will proceed to splice to the next drive and so on.

    • It is normal to see that after a spool runs out, that there is a leftover piece that is about 11-15cm that is too short to splice.

    • With v21.12.21.0, the expected behavior is to start using filament from the first selected drive until it runs out. Once run-out is detected, it will automatically splice to the next, and continue sequentially. When the last selected drive runs out, the multi-spool operation ends.

Conclusion

If you have any questions about this feature, please contact us at support@mosaicmfg.com.

4 other people completed this guide.

Mosaic Support

Member since: 04/02/2020

155 Guides authored

7 Comments

sooooo you cant send over internet to printer for simple gcode file in multi spool!? please tell me there is a way im not seeing this thing cost too much for an archaic method such as this! some please help!

Brooks - Reply

Hi Brooks, you would simply run the print from your printer and feed filament made by Palette into your extruder. There's no need to connect your Palette wirelessly to the internet or send a file to the unit in order to use this feature.

Jonny Yeu -

how can that be?

1. 1) P3P currently supports PLA for multispool mode.

2. yes, ABS and ASA are [multi-spool mode] compatible?

Tim Legler - Reply

Is it possible to use ABS (ASA) in P3P multi-spool mode? Answer yes or no.

micchan - Reply

Hi @micchan, yes, ABS and ASA are compatible.

Adalyn Ordono -

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 8

Past 30 Days: 45

All Time: 1,964

Contact Mosaic Support Team

© 2023 Mosaic Manufacturing Ltd.