Skip to main content

v1.0

Major VersionM

by Adalyn Ordono

Introduction

In this guide you will learn how to:

  • Replace the substructure, splice core, and screen fan on Palette 3.
  1. Remove the bottom casing following these steps. Remove the two bottom screws using the hex screwdriver provided.
  2. Access the back of the unit by following these steps. Release the screen cable from the main board. The screws holding down the main board can be undone in order to access this screen cable better. Flip the unit back to the front. Remove the screen cover, and remove the screen gently by lifting it away from the substructure.
    • Access the back of the unit by following these steps. Release the screen cable from the main board. The screws holding down the main board can be undone in order to access this screen cable better.

    • Flip the unit back to the front. Remove the screen cover, and remove the screen gently by lifting it away from the substructure.

    • Remove the 2x screws from the fan using a T6 screwdriver.

    • Ensure cable goes into hole in substructure next to fan’s spot

  3. Remove the main board following the steps here. Unplug splice core fan from main board Use T6 screwdriver to remove bottom 2 screws
Conclusion

If you have any additional questions, please send us a message at support@mosaicmfg.com.

Mosaic Support

Member since: 04/02/2020

155 Guides authored

2 Comments

Good morning Mosaic team,

can you provide Fan characterystics?

Voltage

Amperes

Fan type

min CFM

many thanks!

Ruben - Reply

Hi @rnunez24, the splice core can is a DC brushless fan, rated 12 VDC, rated 0.21 A. Apologies, I don't have the CFM info available, but I hope this helps.

Adalyn Ordono -

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 9

All Time: 272

Contact Mosaic Support Team

© 2023 Mosaic Manufacturing Ltd.