Skip to main content

v1.3

Minor Versionm

by Adalyn Ordono

Introduction

In this guide you will learn how to remove the connector from the Pi and reseat it in your Palette 3/3 Pro

Parts

No parts specified.

  1. Remove Palette's top lid.
    • Remove Palette's top lid.

    • Using the provided Torx screwdriver, remove the 4 screws on each corner of the substructure.

  2. Remove the IO plate cover from the unit, by pulling the tab on the Ethernet port. The IO plate cover is snap-fit to the unit and can be placed back easily. Gently lift and remove the substructure from the bottom casing. You'll now be able to replace the main board, fans, and other components.
    • Remove the IO plate cover from the unit, by pulling the tab on the Ethernet port. The IO plate cover is snap-fit to the unit and can be placed back easily.

    • Gently lift and remove the substructure from the bottom casing.

    • You'll now be able to replace the main board, fans, and other components.

  3. Locate the Pi(CM3+ Raspberry Pi Compute Module 3+)
    • Locate the Pi(CM3+ Raspberry Pi Compute Module 3+)

    • The Pi is the green board in the bottom left hand corner

    • Remove the Pi by lifting it out of the casing

    • Open the two metal fasteners on each side of the Pi to lift it out of the casing

    • Place the Pi back into the casing and clicking it into place using the two metal fasteners on each side

Conclusion

If you have any additional questions, please send us a message at support@mosaicmfg.com.

One other person completed this guide.

Fatima Kassim

Member since: 09/03/2021

2 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 11

All Time: 552

Contact Mosaic Support Team

© 2023 Mosaic Manufacturing Ltd.